Wiring Sensor Assemblies:
Project 1: Wire +5V, GND, and Data Leads onto Neopixel strips
Neopixels enable control(brightness and color) using a single data line.
To solder wires, cut length of neopixels through copper pads, and tape wires down to hold in place before soldering.
Colors:
Red +V
Black GND
Yellow Data In
To solder wires, cut length of neopixels through copper pads, and tape wires down to hold in place before soldering.
Colors:
Red +V
Black GND
Yellow Data In
For more information, see https://learn.adafruit.com/adafruit-neopixel-uberguide/the-magic-of-neopixels
Project 2: Wire leads onto speakers
Note: May be helpful to hot-glue wires onto speakers for strain relief
Colors:
GND Black
AUDIO GRN or YEL or BLUE
Colors:
GND Black
AUDIO GRN or YEL or BLUE
Project 3: HC-SR04 Ultrasonic Distance Sensor:
Use 4 pin Polulu Crimp Connector housings with female-male pre-crimped wires
- GND Black
- TRIG (not black or red)
- ECHO (not black or red)
- +Vcc Red
Project 4: Wiring Sparkfun Single Reflectance Sensors SEN-1169- GND, +5V, OUT:
Project 5: Wiring Polulu Triple Reflectance Sensors- +5V, GND, A0, A1, A2:
Polulu QTR Reflectance Sensor Guide
https://www.pololu.com/product/2458/resources
Arduino Library for Reflectance Sensors
https://github.com/pololu/qtr-sensors-arduino
https://www.pololu.com/product/2458/resources
Arduino Library for Reflectance Sensors
https://github.com/pololu/qtr-sensors-arduino